首先將搖控器開啟電源，壓住R9000接收機SET鈕不放，開啟R9000接收機電源，直到紅燈LED恆亮，即可放開SET鈕，如下圖所示。 Firstly power on the RC controller, press SET button to power on R9000 RECEIVER and release SET
button when RED LED lit as shown below.
再按一下SET鈕，紅燈LED慢速閃爍，即進入掃描頻率模式，如掃到與自己相同之頻率時，藍色LED閃爍，請使用者確認搖控器是否與接收機相輔，如下圖所示。 Press SET again to see LED flash slowly to enter Frequency Scan Mode; if same frequency detected then t he BLUE LED flashes, an indication to the user if the RC controller is sync with the RECEIVER.
如為與自己相同頻率時,將SET紐長壓,直到藍色LED恆亮,即進入工作模式如下圖所示。與自己的搖控器不相同時請短壓SET鈕，紅燈LED閃爍，如上述2之步驟。 If confirm that frequency is same sync, press SET button till the BLUD LED lit on, indicate that it is in work mode. If frequency is not match with the RC controller then shortly press the SET button to flash the RED LED, as shown as step 2.
工作模示下：Work Mode
開啟搖控器電源,開啟R9000接收機電源,進入工作模式下燈號如下圖說明： Power on RC controller and R9000 RECEIVER to enter Work Mode, the LED indications: 藍燈恆亮：表示接收到搖控器之訊號。 BLUE LED lit on indicates that RECEIVER signal has been received.
藍燈閃爍：表示無接收到搖控器之訊號。 BLUE LED flashes indicate that no RECEIVER signal received.
設定模式下：Configuration Mode:
開啟搖控器電源，開啟R9000接收機電源，按壓SET鈕進入設定模式，紅燈LED閃爍，如下圖所示。 Power on RC controller and R9000 RCVR, press SET button to enter configuration mode, and RED LED flashes as shown below.
紅燈LED閃爍狀態如下：如下圖所示。(長壓SET鈕：是，直到紅藍燈出現。短壓SET鈕：否) RED LED flash indications: as shown below
(hold SET button to confirm, till RED-BLUE lit on. Press SET shortly: negative?)
閃爍一次：表示是否離開設定模式。 Flash once to indicate that whether to leave configuration mode.
閃爍兩次：表示無訊號時輸出狀態儲存。 Flash twice indicates that no signal output status has saved.
閃爍三次：改變輸出狀態。高速(工作模示下紅燈表示)(支援3.5ms Futaba之高級機種輸出) Flash 3 times indicates that output status has changed. High-speed (work mode in RED LED indication) (supporting 3.5ms Futaba model)
